BUILDING changing points FOR A backyard railway
A home-built railway is one of the biggest things you might potentially utilize to shift tons around your farm. [Tim] as well as [Sandra] of YouTube channel [Way Out West] have just such a setup, however they needed some changing points to assist direct carriages from one set of rails to another. Fabrication ensued!
The fundamental design of the railway points.
The railway counts on extremely basic rails made with flat bar as well as angle iron, enabling the railway to be developed without a great deal of heavy blacksmithing work. For a light-duty house railway, these are a lot more than strong sufficient to do the job.
As for the points, a basic V-shaped frog-and-blade style was used. The frog is the V-shaped section where the rails diverge into two directions, sitting in the center of the Y, while the blade is the part that moves to either side to guide the carriages in one method or t’other.
The blade consists of a 2.2 meter long piece of angle iron with a pin welded on, enabling it to pivot. two pieces of flat bar were then welded together with a pin to make the frog. two metal bushes were then required into a wooden sleeper, enabling the blade to pivot as needed. The rails themselves are somewhat kinked as needed as well as whatever tacked down into sleepers with bolts as well as pipe pegs.
The style runs smoothly, much to [Tim]’s enjoyment. It’s a remove enhancement over the earlier style we looked at least year.
There’s something inherently captivating about a railway developed with bit a lot more than wood, metal, as well as hammers. Seeing the bit stone wagon run down the rails to bed in the sleepers is absolutely happy in a method that’s tough to completely explain. video after the break.
[Thanks to Foley for the tip!]